2003 Bmw X5 Transmission Fluid Type?

For Automatic Transmission: 5L40-E. AF3

Notes: Dexron III. Only use this recommendation if the Transmission oil pan is labeled with Dexron III. Do not mix Dexron III with Texaco ETL-7045 fluid.
Capacity: 5 speed 5L40-E Total Fill 9.5 quarts 4.2 quarts Initial Fill

What type of transmission fluid does a BMW X5 take?

Oil Type: Dexron VI.

What transmission fluid does BMW use?

ATF Dexron III is the fluid standard for 4-speed BMW automatics (ZF 4HP). This is also the most common ATF you will find at auto parts stores (it’s compatible with most GM and Ford auto transmissions).

What type of transmission fluid does a 2004 BMW X5 take?

Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.

Can I use dexron III instead of ATF 4?

Use ATF+4 only. Don’t use anything with Dexron/Mercon fluids. These fluids will cause TCC slippage/chatter problems plus wear out your transmission sooner than you would like for. The slipping could also be due to the bands needing adjustment.

You might be interested:  Often asked: 2007 Chrysler 300c Hemi Mpg?

How often should you change transmission fluid BMW?

A rule of thumb with many mechanics say it should be done at least every 50,000 miles. However, the manufacturer’s maintenance schedule for many transmissions doesn’t call for fresh fluid until 100,000 miles – you need to check your owner’s manual to see what BMW recommends for your model.

How do you check the transmission fluid on a BMW x5?

Our Guide to Checking Your Transmission Fluid

  1. Turn the engine on for a few minutes before you check the level.
  2. Locate the transmission fluid dipstick.
  3. Remove the dipstick and touch the fluid.
  4. Use a rag to wipe off the dipstick.
  5. Use a funnel to properly fill the vehicle, taking care to avoid overfilling it.

What is dexron III?

ATF Dexron-III is a premium automatic transmission fluid specially formulated to meet the needs of today’s more compact transmissions, running at higher operating temperatures and with electronic control.

What’s CVT fluid?

CVT fluid is a type of transmission fluid, meant for a continuously variable transmission system. Other names for CVT systems are single-speed, steeples, or pulley transmissions. The other type of transmission fluid is for an automatic transmission.

Is BMW transmission fluid lifetime?

The fluid BMW uses is also known as lifetime fluid (not forever fluid). This fluid is less prone to chemical and viscosity break down compared to conventional oil. It was 3 to 4 times more expensive and it was suitable for up to 100,000 miles.

How many quarts of oil does a 2004 BMW x5 take?

Capacity: 7.9 quarts…. (with filter)After refill check oil level.

You might be interested:  Bmw Engine Reliability?

What kind of transmission fluid does a 2008 BMW x5 take?

Valvoline MaxLife Synthetic Transmission Fluid Multi-Vehicle 1 Quart.

Can I mix ATF 4 and dexron VI?

MaxLife® ATF, ATF +4 and DEXRON® VI are all synthetic transmission fluids. Is it OK to mix synthetic ATF with a conventional and/or synthetic blend ATF? Yes. Synthetic ATF and conventional fluids are 100 percent compatible with each other.

Can I use dexron 2 instead of ATF 4?

ATF IV and Dexron II are different enough I’d suggest against using it, however all Dexron fluids are backwards compatible, so you could use Dexron III or Dexron VI. If you can get Dexron III you can mix it with the exiting Dexron II in your power steering reservoir without issue.

What is the difference between dexron III and dexron VI?

Dexron VI is a lot more stable at higher temperatures and lasts longer. It can also be used to top off dexron 3, however, you can’t use dexron 3 if you already have dexron 6 originally in your trans, or if it has been flushed with dexron 6.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top