Question: Resetting Bmw Oil Service Indicator?

So this is how you reset it:

  1. Turn on your car without starting the engine. Put the key in and don’t touch any pedals then push the START button once.
  2. Hold down the RESET button.
  3. Display the ENGINE OIL.
  4. Press and hold the RESET button.
  5. Hold it again.

How do you reset the oil light on a 2016 BMW?

To reset the oil level warning or maintenance light in your 2016 bmw 328i vehicle, turn the ignition key to the “on” position and depress the gas pedal slowly three times. Release and start your vehicle and the oil light should indicate a reset.

How do you reset the oil service reminder?

Hold the Reset Button and Turn the Key Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

Why is my service light still on after a service?

As mentioned earlier, the service required light is mainly used to remind drivers to change the oil and filter. When the light illuminates, you should take the car to be serviced at your convenience. After the repair work is done, a reset procedure is usually necessary to turn the light off.

Why is my oil light on after an oil change?

The light could be on after an oil change because of an issue with the oil pump. If this is the cause, there could be not enough oil circulating through to the various parts. Performing regular oil changes should help prevent this from happening, but parts do wear out.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top