Readers ask: 2002 Acura Tl Srs Light Reset?

To reset the SRS light on the Acura TL you need to turn the key to on, wait for the air bag light to come on. Once it does wait 7 seconds for it to go off then turn the car to off. Now repeat this two more times and it will reset.

How do I reset my SRS light?

How to Reset an Airbag Light

  1. Put the key into the ignition and turn the switch to the “on” position.
  2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
  3. Repeat Steps 1 and 2 two more times.

What does SRS mean on a 2002 Acura?

SRS ( supplemental restraint system ) Air bag system.

Will disconnecting battery reset SRS light?

Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.

You might be interested:  What Is Eco Pro Bmw?

Can you drive with the SRS light on?

While you can certainly drive while your SRS light is on, it isn’t safe. You should get your vehicle to a service center as soon as possible so that a technician can inspect your SRS computer.

What would cause the SRS light to come on?

If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.

How do I check my SRS airbag?

When the vehicle is first started, the SRS light should illuminate for 1 to 5 seconds while the system goes through a self-test sequence. If the light goes out, then the system is ready. If the light stays on, there is a fault somewhere in the SRS system. The system is disabled at this point.

What is an SRS warning light?

The SRS warning light indicates a malfunction in the airbag system, front passenger occupant classification system or the seatbelt pretensioner system.

Can a blown fuse cause the airbag light to come on?

Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.

How much does it cost to fix SRS light?

What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic.

You might be interested:  Quick Answer: Are Audi A6 Reliable Cars?

Is it legal to reset airbag module?

You certainly can remove the SRS airbag module from your vehicle and reset the unit to factory settings; you need to have the right tools and follow the steps correctly to succeed in resetting it properly. To begin the process, you need to remove the SRS airbag module from your vehicle.

How do I turn off the SRS light on my Acura RSX?

At this point, take the key out of the ignition and put the 2-pin clip back in to the proper place (same place where you took it out). Secure the bottom dash back in to place. Test out the SRS again with the Ignition Position II. It should beep then the SRS should turn off.

How do you reset the check engine light on a Acura RSX?

To reset the maintainence reminder light turn off the engine press and hold down the “reset” button on the instrument cluster, turn the ignition key to on (not engine running) and keep the reset button held down for ten to fifteen seconds and then release.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top